Gene's Mold Facts (FOOD SAFE)

Silicone: Smooth-On SortaClear 18 Platinum Cure Silicone (MSDS)

Maximum PSI before warping mold: 40psi

Font License

Your molds can be cleaned in a tiny amount of dish soap and water if needed.

Your molds will unfortunately deteriorate overtime - this is inevitable - there are a few ways to mitigate this though. Always make sure to be very gentle around the edges of the 1 faces when you're unmolding and be sure not to leave any excess material in or on your molds and they should last you at least 10 casts. You can increase this number by using a mold release such as Pam Cooking Spray - however this will dull that glassy finish down to a satin finish. 

  • [nerdy-form:13741]

  • [nerdy-form:14882]

1 of 2